2 bbl to /6

Hello Frank,
It's not too tough to adjust. The trick is getting the 1.7 inch of "pull" on the cable from the idle position to the WOT position of the carb linkage. This is why I put a slot in the piece I added to the linkage bracket on the carb.You set the KD to be fully pulled when you are at WOT. The lower section on the trans uses a (supplied with the Lokar kit) bracket bolted to the trans. Since the stock rod pushed the lever in the trans and the cable pulls the lever the cable is routed down the trans tunnel and loops back near the tail shaft where it meets the supplied bracket. It's an easy install. Sorry but I did not take any pictures. My car is pretty low and my lift is tied up right now with my 55 T-Bird. You may be ablt to access the instructions from Lokar's website.
Take Care,
Wayne