S.O.S. I need some help here....

pull the number one spark plug and jump across the starter relay till compression comes out of the number one hole(use finger tip over the spark plug hole) then pop off the distributor cap and make sure it is pointing to #1 cylinder,install itermediate shaft then distributor so rotor points to #1 then turn distributor so that the points are just about to open or pickup is pointing to proper place on electronic ignition cars.then pop the cap on and run your plug wires,snug down the distributor to where you can still turn it.then set the emergency brake and chock the wheels...turn ignition switch to the on position and then you can jump across the starter relay terminals to start the engine.....should fire right up! hope this helps