plug reading

The outside air bleeds should be about .063 or so and I want you to find out what drill that they are and drill them .005 larger. .068-.070 will do the trick, but if you woble and drill them larger then you'll have to jet the primary side up about 3-4 sizes.

You need to have the front fuel bowl off and have a air chuck handy to blow out the chips that the drill will create. When you look at the carb when the fuel bowl is off you'll see 4 holes near the top ring of the carb just under the airhorn that coinside with the air bleed holes in the airhorn. These are the ones that you need to make sure that they aren't restricted in any way. When you get this done you should be fine.