Just general bitchin

Geez...this is never gonna end.

Tonight I popped the new and CORRECTR fuses into the new box getting ready to put it in the dash. But before I did that I decided to pull the door switches and clean the paint off them, thinking it would aso make it easier to plug the new wires in to them.

Well I was wrong. The wires for the switches have a small TWO PIN connector on them that plugs directly in to the switch. One of the switches is made for a THREE PIN connector, the other for TWO small SPADES.

Not only that, but both holes for the switches are wallowed to the point that these switches really won't screw back in and tighten up.

Any ideas on how to fix THAT? And oh yeah, these aren't small diameter switches like the B bodies use. %$(@$^%@*