Spark plug wires with comp headers?

-
LXguy

LXguy

Well-Known Member
Joined
Jul 23, 2008
Messages
2,302
Reaction score
109
Location
Champaign IL
Hey All:

Does anyone have a good recommendation for a set of pre-cut wires for use with the Hooker Comp headers. Looks like I need 90* boots on cylinders 5 and 7.

Any help is appreciated.

Steve
 
I just went with spark plug wire boots with straight plugs. I have had no melting issues. I think they are made by DEI.
 
I use Accel 8mm wires with 90 degree boots on all 8 sparkplugs and they work great with my Hooker headers.
 
90* ends and you can either run them super tight to the valve cover and up, or, loop them out down, out towards the master cylinder and up over everything. I used to route mine the second way. Used a tower off the rear valve cover bolt.
 
No matter the wire used, I suggest the use of a sleeve to help stop the heat and protect the wires from being burned. Those 2 cylinder 5 & 7 are a pain.
 
You must log in or register to reply here.
-

Back
Top