Do I have to re-bleed, or what?

MOPEkidD-3 said

I was testing my brake light switch today because I thought it was broken (turned out to be a fuse) and I unknowingly lifted the brake pedal up past its normal resting position. After I pushed it back down I noticed immediately that there was now 2-3" of dead spot before the pedal would get hard whereas before there was less than an inch. Did I somehow get air in the system when I lifted the pedal, and if so do I have to bleed all four wheels? BTW this is a 1970 Duster with the original Kelsey-Hayes manual front disc brakes. The brakes still work and I can drive it just fine but it makes me uneasy having that much play in the brake pedal.

Click to expand...

Not sure of the brake pedal question but did you check the level of brake fluid? If it was real low at the time you pulled the pedal back you could have sucked air I guess. Is it possible the pedal shaft backed out of the master cylinder a little? I would go ahead and check fluid level, put lid back on master cylinder. Get in car and depress pedal all the way down to floor + a little force to see if the shaft slides in further and pops back in. If that doesn't correct, you might have to bleed the master cylinder at its lines. Sorry 70 is too new for me.

I was wondering however, how many fuses did you blow? did this one go the same time as your dash light in the other thread? If so, heres what happened to me. Bad voltage regulator took out my dash lights (both bulbs and dimmer switch), dome light, turn signal bulbs front & back, indicator lights on fender, alternator, headlight switch, flashers, all before I could shut down! (every lamp on car while trouble shooting) After replacing everything else first I finally got to the headlight switch & replaced too, now everything OK.
Good Luck!8)