Post/debate your stroker small block builds here
My low buck 410 stroker
360 .040 over
w/torque plates, Cleaned, mag'd, main studs, line honed, square decked w/arp studs=$590
Ohio crankshaft nodular iron 4'' crank kit w/H-beams and KB 356 quench domes, moly rings, clevite rod/main bearings internally balanced=$1300
Free J heads that I ported myself flowing 200 @.300
[email protected] 270'
[email protected] 280's@ .530 + Machining-seats on both int/exh, guides 11/32 stainless ferrea/engine pro valves,seals, cc correcting/milling of deck/intake, multi angle VJ,back cutting=$847
Billet timing set,milodon 8 qt pan/pickup package w/melling std oil pump, gaskets, comp push rods, hardened pinned gear intermediate shaft/bushing, engle solid KV3 custom grind .573 lift 282* 252*@.050 110, mopar solid light weight lifters.005 undersize, engle springs, comp 740 retainers with comp +.050 10* keepers for 1.80 installed height=$930
I use bolts off core motors if I need anything like cam thrust plate hardware and even reused a cherry thrust plate.
I'm buying a proform 850 annular for $250 off a guy later this week.
And I'm using an LD340 I paid $90 yrs ago.
Power goal 490-520HP@5800-6200rpm 480-500ftlbs@3800-4400rpm
Grand total $4,007 +/- $200