Windhield moulding clips

The stainless reveal mouldings use the same clips all around.
Vendors will sell little bags marked front window and rear window but the only difference is the count enclosed.
Now about the bottom of the vert windshield.. The plastic insert locks the gasket. You can put a stainless moulding there and marry it to the verts A-pillar stainless easy enough but you'll need something in the gasket too.
The lower stainless moulding from a hard top wont lay on that gasket just right either and might produce a wind noise, whistle.
I would say dry fit the gasket with whatever replacement insert you choose then lay the stainless on and figure out how deep to set the moulding clips and what if any gasket trimming is needed.