wth - another prob. torsion bars wont go back in

Lift the front end off the ground.
Loosen the nut on each lower control arm,but leave the nut on.
Stick a pry bar between the lower control arm and k-frame. Push them out a little,freeing them up a bit.
I will also take a pair of channel locks and spin the torsion bar mounting hole of the control arms,so they are in the right position for the bars.
They should now slide in.If they are close a slight nudge with a small sludge hammer should seat them.
Make sure you have grease in both torsion bar mounting holes.