Post/debate your stroker small block builds here

Here is the combo I had in my 'Cuda:
360/408
Eagle steel crank,I beam rods,Probe pistons, file fit rings, 10.5:1, zero decked, line bored, torque plate hones, Eddy Magnum heads w/clean-up and gasket match and upgraded springs, Eddy Magnum RPM intake, Holley HP Street 750, Hughes hydraulic roller cam 228 @0.050" (HER2228?), pulled 11" Hg at idle, ARP studs, Comp Promagnum 1.6 rockers, TTI headers, est 460bhp based on Hughes Engines testing, quite docile around town but pretty mean at WOT, never dyno'd or tracked:thumbdow: (sold) I could easily bump the hp up with more cam and some minor porting. Hughes said a bigger cam was pointless without porting.

I didn't add up the cost but remember thinking about $7500??? Cdn. The hydraulic roller cam was costly.