please help me!!!

Install TBs before tightening strut rods. Put TBs into LCAs hanging down and UCA bump stop removed. "Loosen" jack screw until top of screw allows tab in LCA to contact block on jack screw. Hold tab down on block while inserting bar.

Once TBs are installed, the strut rods can be tightented to 110 ft/lbs in front, and 30 ft/lbs on the nut in the rear. Before adjusting jack screws, bounce car up and down or move fore and aft a few feet to allow tires to sit properly on pavement. Remember to re-install UCA bump stop.