Looking for suggestions on quarter panel repair

kanders is also right....if theres to much rot,you may just want to get a patch panel....wich is pretty expensive for mopars...I tihkn I priced out lower duster rear quarter panel patch's at around $180.00 without tax or shipping. so its not the cheapest route,all depends on how much money you want to spend and how much work your willing to do. if you would rather,take the sheetmetal you plan on putting in plaze of the rusted area....do this step prior to cutting by the way.......grind a couple spots in the body so its clean metal underneath....hang a piece of sheet metal up so it covers the entire rusted area.....tack weld it in a few spots so that it will not go anywhere.......then take a body hammer and some people find a propane or map gas torch helps....but its not a must.....tap the metal over and over until you form the contours you need the sheet metal to be shaped to.....get the shape you need at the lower end where the lower quarter kind of folds in at the bottom. as for your wheel wells, if they have rust....just cut an overhanging flap on the side of your patch panel and take tin snips and cut a bunch of slices in them and when you fold them over,they will form the contour of your wheel well. you can then grind off your spot weld,pull your sheet metal off,trim it up to match what ever the measurements you plan on cutting out of the quarter panel itself,then place your new piece of tin up inplace and it will already be form fitten and contoured to the body panels....minore imperfections and low / high spots are ok,you can always give it a couple more taps with a hammer and smooth it out and don't forget you will still need to do body filler anyways to smooth it all out....judging by the pictures, it wouldnt be a bad one to do...just take your time ( MEASURE TWICE, CUT ONCE ) rule of thumb lol. you will get it!!!