8.25 Centre and Sure Grip issues

Looked at it again today and hand fit the carrier with bearings into the rear end housing, without the caps installed.

The carrier is at its max adjustment towards the passenger side, meaning that the passenger side bearing is bottomed out in its travel that direction, and the backlash is still way too large.

There is no interference with the diff housing and carrier. So the grinding mods in my case will not help.

only a ring gear spacer will help, and I havent found one for this application. The gear flange on this posi unit is .275" below the flange on the original non posi diff carrier.

good luck I am putting back in the non posi center.