Camshaft comp cams bend or not

Darthemi - I read your post as 9 ten-thousanths or .0009" and 7 ten-thousanths or .0007" . If this is correct, you have nothing to worry about. There isn't much in cma bearing clearances. They get a ton of oil, they simply rotate in the bores, and the surface area vs the forces going through it is very high. You're fine. If you meant 9 to 10 thousanths, or .009-.010" then you have may have an issue, but each cam bearing has a unique dimension. So there will be some variation anyway. I dont have a new Comp cam to measure here or I would...