Installing replacement 1/4s?
I just finished mine on my 71 demon. I bought the AMD full 1/4 and it was nowheres near as hard as I thought it would be. I used a torch and melted out the body lead to see where it needed to be cut. Drilled out the spot welds removed the old panel. Slid the new 1/4 into place. A few minor adjustments, drilled some new holes and then put it on and welded it in place. Bit of bondo to fill the seems and presto, good as new. Did this outside beside the garage in the summer time.
kenny b
I just finished mine on my 71 demon. I bought the AMD full 1/4 and it was nowheres near as hard as I thought it would be. I used a torch and melted out the body lead to see where it needed to be cut. Drilled out the spot welds removed the old panel. Slid the new 1/4 into place. A few minor adjustments, drilled some new holes and then put it on and welded it in place. Bit of bondo to fill the seems and presto, good as new. Did this outside beside the garage in the summer time.
kenny b
