turbo 360

DODGESTRIKE said
its me again the other built isnt going to hapend buut i have a 73 duster body i wanna do the turbo on it full race car , just 2 seats and autometers haha

the motor a 360, .30 over dish forjed pistons 8.5cr to use 92 octane and scat h beams , for strengt but a stock cast crank ( low budget )

fuel system fuel cell, aeromotiveA1000 with fuel regulator , -8an braided lines, strip dominator intake , blow throug 750

also automatic trans a904 , hughes 3,500 torque convertor, and a 4.56 gearing with some 28x105 slicks

and i saw anotherA isnt using a intercooler do i need one or not ?

for turbo i was looking in ebay and saw a holset ht60 will this work whit my combo ?

92 octane on regular and sometimes race fuel ...again 92 is cheaper :D

Prine and anotherA are the guys to go to on here for turbo...i suggest looking in the mopar section over at the turboforums.com as there is tons and tons of information there...turbos are defnatly a lot of work, especially fabbing, so i hope you have the skills for it...im no turbo guru, but if you want in the 10's or even 11's with a turbo i think a set of 3.55's are enough to turn the tires to mush- that may even be too much as well...and the 904 you have im hoping is built up as it needs to be able to take the power and shock of boost...also, i personally think an intercooler is a must especially with your goal- if you want the power and want it more reliably, get an intercooler as it will only help you....also, you dont have to buy a carb done, if you check out the turboforums theres a whole article there about modding a carb yourself to make it blow through, which shouldnt be too hard to do in light of tackling a whole turbo build..good luck with everything!