1.98 Rear End?

Charlie, and everyone else, thanks for your help. I'll have to try your method to see what gears I have. As to my method for determining the 1.98, I taped a paper tape to the driveshaft (the circumference of the shaft was 10.25") and aligned the "0" up with a rafter square so that I could determine exactly where the shaft stopped. I then put a strip of tape on the wheel, and aligned it with another square so that I could determine when the wheel had made exactly 1 turn. When I made 1 turn of the wheel, the driveshaft had rotated exactly 1 full turn plus 10" out of 10.25". 10 divided by 10.25 is 0.975, so I assumed that I had 1.975 or 1.98 gears. I checked the measurement twice, and got the same answer. I'll have to check it with the 1 wheel method, and see what I get.

Thanks again to all who replied.