904 Selective Thrust Washer
It is a small round washer, sometimes looking and has 3 small humps on it like a clover leaf. Wish I had a better pic. It goes on the input to output shaft.
OK from the book it is #3 in the picture I made for you buddy.
Apply a light coat of grease
to selective thrust washer and install washer on front AND LOCKNUT
end of the output shaft. Apply a light coat of grease to
input shaft thrust plate and install over input shaft. If
input shaft end play was not within specifications
(.022 to .091 inch), when tested before disassembly,
replace washer with One proper thickness
Some specs
# 3 Selective
,052 to .054 inch (Tin)
.068 to .070 inch (Red)
.083 t-o .086 inch (Green)
PS DONT forget the snag ring seen this left off many times it goes on the end of the output shaft to hold the lower end in place so it wont walk up the shaft. :)
It is a small round washer, sometimes looking and has 3 small humps on it like a clover leaf. Wish I had a better pic. It goes on the input to output shaft.
OK from the book it is #3 in the picture I made for you buddy.
Apply a light coat of grease
to selective thrust washer and install washer on front AND LOCKNUT
end of the output shaft. Apply a light coat of grease to
input shaft thrust plate and install over input shaft. If
input shaft end play was not within specifications
(.022 to .091 inch), when tested before disassembly,
replace washer with One proper thickness
Some specs
# 3 Selective
,052 to .054 inch (Tin)
.068 to .070 inch (Red)
.083 t-o .086 inch (Green)
PS DONT forget the snag ring seen this left off many times it goes on the end of the output shaft to hold the lower end in place so it wont walk up the shaft. :)
