Rocker Stands For Magnum Valve Train??

Moper,

Ok, I looked at it again and there is no way that by raising the rocker it will change the way that it sweeps across the valve tip like explained earlier.
The rocker stud is angled toward the spring and valve so as you raise it, the problem gets even worse. Maybe the rockers I am using are a pieces of S&^%$!!tt, they are totally based on the SB chevy I guess like most of them out there. Just another reason for me to HATE the Magnum Valve Train set up...........LA all the way from now on!!!!!!!!! It makes me wonder if when the studs were re drilled and tapped and the pad machined down a bit that it was done on the correct angle........???????? Do you have a picture of a Magnum head with the stud in place so I can see the angle of your stud compared to the spring and valve. If it was off only a little bit, by the time you go up the stud it could be quite a bit off and the geometry would never be correct no matter what I do........I am scratching my head now, thinking that is the problem for sure........I need to find out!!