Geen bearing install

Got er all done today. Just had to wing it, which really was no big deal. My factory axle seals were "iffy" so I installed the new ones.
Mine are a bit different from those in your pic. The retainer is actually part of the bearing on the ones I bought. Pull off the old and press on the bearing...heat up the inner retainer and press it on.
Tomorrow morning I'll slide the axles in, bolt 'em up ...slip in the new speedo gear and take a nice ride. Supposed to be 65 degrees and sunny here in PA.
Honestly today, the hardest part of the whole swap was getting the old center section out without it falling on my chest.........supposed to do that tomorrow with a buddy but just couldn't wait. I'm sure you know how it is.