3to 349 stroker who makes them?
My old 349 build -
Cast 360 crank cut down in the journals.
360 shot peened rods
The guy that built mine used hi comp TRW forged slugs cut down 100th. Comp was good, P-V clearance was pretty bad. :(
Doing it again on the cheap, Id use the silvolite 1278CP and fly cut them.
I ran 10.4:1 comp,
234@ .50 / .495 lift cam
Unported 1.88 valve 360 596 cast heads.
3.9 gears
Ran a best of 13.1 at 104 mph (3600 lb car) on street steel ply radials.
The problem with the 349 build has ALWAYS been finding a slug that gives the P-V clearance you need.
I am now getting a 318/390 done - its costing $300 more than the cheap 349 would cost me, and I get more cubes, I can run a bigger cam and forged KB slugs.