The wheel looks very good, color matched and all.
Heres an idea for the horn pad...
matching woodgrain but circular like cut end of log, black emblem suggests burned or branded into. A graphics shop could probably make up something on stripe vynil.
Now on a sour note... If you bent the signal wand in place without heat, it bent in the weakest point which is the hole for the retaining screw. Lets hope it didn't crack. If you ever pull the plastic knob off and hit that stem with a hacksaw you'll find out just how hard the material is that the factory used there. I went to the extra trouble to remove the wand. I shoertened the black plastic knob and stem about a half inch and used a torch to lessen the bend angle about 10 degrees.
