360 camshaft for 8.4:1 engine

I think the comp xes are the best bet for your build,the 110 lobe sepeartion is good,either the 262 or 268,also using rhoads lifters with an agressive ramp can make alot of noise but also is a bit over kill since the cams designed already to give you better idle and vaccum.I used a xe274 in a 360 with 8.7comp,mild stall and 3.23s and it ran hard,no issues at all,just get the tune right and if your not already use the thin head gaskets to get the most you can.

Lead69, Looking for the cam that will work best with my already purchased rhoads & 8.4:1. Current comp. was figured with an .0475 head gasket. I could re-figure with the .024 gasket. Any problems with the thin gaskets sealing? That just sounds a little risky to me. Never used a skinny one before.

What special valve train components / work did you have to run to use the comp. xe274?
What rpm did the motor really start pulling for you at?

Thanks for the input lead69.[/B]