360 con. rod bolt sizes

It all depends on what your plans and expectations are with this 360.

With those pistons i would not run over 6500 rpm.

I would do some checking into aftermarket rods. I was told a few weeks ago by my machinist he could get me a set of aftermarket rods for a few more dollars than reconditioning stock rods. By the time you resize the big end and put new bolts in thats close to same price as an aftermarket steel h beam.

Was honing plate used on the final bore? Just cuious. I have seen a lot of engine talk on here but have yet to see anyone mention anything about a honing plate being used. I feel its an absolute must in engine building.

Hope this helped.