Went for a run around the block with no exhaust & it sounded hot. Need to do the timing as I could here a bit of pinging going up the hill.
With the new front end , wheel alingment & brakes it handles quite well. Getting the exhaust done as a 2.5" twin with no balance pipe from the engine back.
Have also ordered from Summit a set of 4 into 1 headers with 3.5" collectors, after looking at the front end there is not a lot of room to fit them.
ANY HINTS ON THE BEST WAY TO INSTALL THEM?
It looks like an engine out job or drop the whole front end out.