Removing Rear Bumper

Inside the trunk on the rear panel is the bolts you are looking for. Just stand right under the lid and look down and you will see the bolts on both sides. You can remove them without any help. Remove all of them on each side but leave one top one on each side threaded in just enough to hold the bumper so you can get your leg against the bumper and finger turn the two leftover bolts off. Then reach by the license plate area of the bumper and pull it away from the car and you are done. Its pretty basic. Do remember to unhook the wiring before you do all of this though. There are two plugs going to the wiring and the wires have a large rubber grommet on them going into the back panel leading to the bumper. There are two of these rubber grommets. After you remove the bumper from the car you can take off the mounting plates so all you have is the bumper shell. Good luck!!
Chas.