Subframe Connector dilemma

I went with the "build your own" type out of some rectangular stock wide enough to slide over the frame at the rear but short enough not to go through the floor. Total cost was about $50.
Personal experience of handling improvements:
The car seems more "sure footed" - before the connectors were in it felt like it always had a low tire, but maybe that was just in my head.


Brad, My 73 /6 duster had some tears in the floor at the trans cross member spot welds among other places. Obviously not a race car, BUT the car did have a tow hitch on it and I found an old registration for a 14' boat in the glove box. So my 73 has seen it's share of beatings.