Newbie from Holland
:thumbup:
In one of the earlier posts, you can see that I have since changed the single diagonal track locator to a X-brace one and constructed the main one from bigger pipe. The 2 bottom rods still need to be redone to make them sturdier too.
Between the front mounting points I'm going to connect a rear driveshaft loop and the cage will have 2 points welded to the mounts as well. This will be to tie it all together. When the cage is in, I can make some caps to fit over the holes in the floor and close them up again (much like the center tunnel but only short pieces).
Here are some more shots of the headers. I constructed them myself (took about 10 hours per side) and had a friend with a TIG welder finish them after I tacked them all together. They drop in from the top without removing anything and I have clear access to all the plugs.
Later,
~Alain~
:thumbup:
In one of the earlier posts, you can see that I have since changed the single diagonal track locator to a X-brace one and constructed the main one from bigger pipe. The 2 bottom rods still need to be redone to make them sturdier too.
Between the front mounting points I'm going to connect a rear driveshaft loop and the cage will have 2 points welded to the mounts as well. This will be to tie it all together. When the cage is in, I can make some caps to fit over the holes in the floor and close them up again (much like the center tunnel but only short pieces).
Here are some more shots of the headers. I constructed them myself (took about 10 hours per side) and had a friend with a TIG welder finish them after I tacked them all together. They drop in from the top without removing anything and I have clear access to all the plugs.
Later,
~Alain~
