W-2 exhaust guide

ou812 said

That's just the guides! Intakes are 9.00 a piece. We remove the old guides, clean the head in a glass beader, tank it, dry it and heat it.
We then install the guides with epoxy and keep the head hot for an hour, then let it cool at a specified rate.
It takes some doing. Then you have to do the valve job.
We charge 750.00 for all the guides, honed and installed, valve job, surface cut and assembly.
Any porting would be extra.

Click to expand...

This is the dilemma, I figured I would come to. By the time I buy new springs and retainers. I will be very close to the cost of those new RHS heads you are selling, (although I don't think they will make the H.P. these W-2's will) but would be more street friendly. Your in line to price what the local machine shops cost would be and I don't trust them. I would perfer you to work on them. What is the usuall shipping on a set heads like this from the East Coast to your shop. Have any idea? Also would you sell a single exhaust guide? The other guides have liners in them, that seem to be holding tolerences, but the machine shop doesn't like the idea of using them with the liners. any suggestions..
T.J.