SB Stroker....One more time

It sounds good to me. You will need to upgrade the valve springs for the cam as Edelbrock's don't have the pressure you need. You will want to use the 1008 Felpro Performance head gaskets... They are .039" thick compressed and have the preflattened fire ring to avoid brinnelling of the heads. Wth a flat top at zero deck and 65cc chambers you're looking at 11.4:1 and with that cam that should be fine for pump super. You could also go dished but I think if you do the idle will be a little rough as even the smallest dish puts it down to 10.2. As far as the cam... Make sure the lifter bores are no larger than .906 and make sure the engine is fired immediately and the inner springs are left out during the cam break in. You should have no issues.