My 360 Magnum build thread

I can't see the pictures but a few remarks... What you see for variance is normal for any factory machined parts. This would be why I have it all fixed when i do an engine. I want better than Mopar did it..lol. On the rods... If the order is all mixed up anyway... Have them all re-sized properly and put in some good bolts. But if they are pressed off there is a good chance they will be junk after, and even if they aren't pressed pin don't work as floaters... So be aware that pistons should be in your future. Also, make sure the shop decking the block knows what square decking is and has the equipment to do it. I know some average machinists who say they sqaure deck but can't because they dont have the fixture or equipment for it. They just don't know what the difference is.