How to get my car into 12 seconds?

you probly will not have enough money to hit the 12's.
well, i really don't know how much money you will have ,but here is some info.to give you the basic setup.

Remember it has to last and not break and you have to many things to buy to keep it cheap.
Start with what you have and go from there with reliability in mind.
Also spend the most money on the most important stuff.

You have a intake(holley strip dominater intake)
carb(edelbrock thunder series 600)
used 360(in good condition and having no problems)

What you will need next is to complete the motor.
Heres a good all around combination for you.
call paw
camshaft \\ paw-221146 453lift\\224 @ 50 108 lc single pattern
(this cam will work with a stock or performance torque converter)
IF YOU CAN SWING A CONVERTER GET A 9 1/2 DYNAMIC 3500 STALL SPEED WITH A TRANS COOLER.
lifters part# 2011
valve springs vs-150 \\new valve seals
double roller timing chain\\
headers 1 5/8 dyno max
GET A COMPLETE GASKET KIT FROM PAW replace all gaskets except head gaskets.
carb spacer \\ four hole 1 inch jegs
mancini racing air cleaner \\ cheap = 24 bucks good for hood clearance
carter fuel pump \if changing fuel line go to 3/8
msd wires
msd coil
mopar performance crome box ignition
take your stock electronic distributor and install a set of lightweight springs from mancini =$12.95
auto light 3924 plugs
new fuel filter \\steel filter \ install before fuel pump
your half way there \\\
new muffler system \\get the mufflers from jegs or summit and have a local shop put pipes on the car and stop before going over the rear axle.(cheap)3 inch
MOST IMPORTANT PART OF THE CAR AND WERE THE MONEY SHOULD BE SPENT.
BRAKES \\ MAKE SURE THERE GOOD
REAR GEARS AT LEAST A 3.91 AND A ADJUSTIBLE PINION SNUBBER.
TIRES \\ BRAND NEW DOT STREET SLICKS HOOSIER QUICK TIME PROS.
26 INCH TIRES
A CHEETAH VALVE BODY SO YOU CAN SHIFT THE CAR WHEN YOU WANT TO.
17676 CHEETAH #
NEW TORQUE CONVERTER BOLTS.

A TACH (SUN PRO 2)AUTO ZONE 45 BUCKS
NEW UNIVERSAL JOINTS ON YOUR DRIVE SHAFT FRONT AND REAR.
ALL NEW MOTOR MOUNTS AND TRANSMISSION MOUNTS.
GET THE MANCINI MAG MOUNTS \\ THEY DON'T BREAK AS EASY AS STOCK
Thats it in a nut shell \\ oh and don't forget oil\coolant\hoses\clamps\fuel
inspection\reg and ...........................

I hope you heard this motor run before you do all this work.
If not, i would try to get info on how it ran and if it smoked at all from who you bought it from .
check the motor out if you don't know.GOOD LUCK
P.S. IF THE CAR GO'S 13'S YOU WILL NEED A DRIVE SHAFT LOOP.
AND YOU WANT TO GO 12'S:evil4: \\\ HEY YOU NEVER KNOW.







run stock torque converter \\ save money
add everthing up before you start so you know you have enough money.