72 duster Build progress
Wire wheeled,patch a couple minor pin holes,primed the hole thing and than sealed it with many coats of black enamel
More floor pictures
Nice and shiny and new
Front end back on and body work started
There was about an inch and a half of bondo on this quarter with a pool of water underneath but I caught it before it rusted out and I popped the dents out of the quarter and the door
More body work
Even MORE body work
Some bondo work that I need to finish and I made a quick patch panel for the lower rear quarter and then I need to do another thin layer of bondo on most of the quarter and start smoothing it all out
Pretty much the same on this side
Picture of the front ( i know the holes in the hood are to big, owner before me matched the holes to the scoops
Wire wheeled,patch a couple minor pin holes,primed the hole thing and than sealed it with many coats of black enamel
More floor pictures
Nice and shiny and new
Front end back on and body work started
There was about an inch and a half of bondo on this quarter with a pool of water underneath but I caught it before it rusted out and I popped the dents out of the quarter and the door
More body work
Even MORE body work
Some bondo work that I need to finish and I made a quick patch panel for the lower rear quarter and then I need to do another thin layer of bondo on most of the quarter and start smoothing it all out
Pretty much the same on this side
Picture of the front ( i know the holes in the hood are to big, owner before me matched the holes to the scoops
