Clutch Rod and Pedal Problems

If it goes in enough to disengage and comes out far enough (foot or otherwise) to achieve a little free play (i.e., completely "en"gage, with the TO bearing free), then is it probably just spring issues and the related matters of mismatched conversion pieces.

For example, mine has a homemade Z-bar and only comes out about 3/4, or sits about two inches lower than the brake. It works fine this way, as long as the above conditions are met. Check all the pivot points and links and proper function, ensure the springs are there and working good, should be all set.

You may find (as I did, upon re-assembly) that things are not lining up quite right, and need to do a little re-fabricating to get it working good.

:thumrigh: