Header flange to round pipe interface

Bill Dedman said
Boy, that sounds like a lot of hands-on fabrication for a lazy guy....

A "craftsman" I am not; my idea was to buy a set of cheap headers, and cut the primary pipes off about 5" from the flange and weld-on some 90-degree bends and go from there....

But, I can't find any "cheap" headers.... any ideas???

Heck, My idea was to chop off the flanges on an old exhaust manifold with a plasma cutter and fab from there. They are only about 125$ on another site. But, headers by ed sounds like a better way to go cause he would probably charge you for around the same to make those 5" pieces