With schumakers? all motor? Easy, just cork a big motor with them done. those 11.50s were all motor in a heavy car with the schumakers. The hedmans woulnd't be a cork til your going pretty fast. Im just finishing this up(you know when you got a certain et you have to have one of those tranny shields ours is kevlar.)
[ame="http://s609.photobucket.com/albums/tt177/Gearjammer50/Mobile%20Uploads/?action=view¤t=0324001059.jpg"]Mobile Uploads :: 0324001059.jpg picture by Gearjammer50 - Photobucket[/ame]
I bet I could get a 10sec pass on pump gas(allready done it with the ttis easily) with this motor and schumaker tri ys,would be choking it but the headers that r on it are a little big to be ideal(2in TTIs) Must be some weird voodoo thinking a 383 wont run with an 1 3/4 primary header(hedman I just went and measured a set we have hangin on the wall) even up around 500hp no sweat. And the dinging needed is minimal if you check it alot as you go.
Good luck,
Jr.
