Pulling a 318 and 904 together- advice please!

avarageerod said

i was going to upload the pics to this thread, but I thought I would just post a link.

http://www.forabodiesonly.com/mopar/showthread.php?t=62997&page=2

post #65 are the pics I'm refering too. Of coarse, you'd want to be a little more careful with your car than I was. LOL

Click to expand...

Boy, I'll say! I laughed hard enough to get tears! Now THAT is Southern Engineering at it's finest- plow straight ahead. . .over, under, or THROUGH to the finish. That's how to get the mission done!

Q: your frame ties- any rubbing on the body, anything you did to seal rust from their insides? I was going to fab 3x3 ties and weld, but am now looking at Auto Rust Tech ties that look a bit flimsier but tie against the entire floor pan front to rear with the usual spot welds. POR 15 inside the darned things? Drill for draining? Me, I am kinda looking to stop rust even from hot/cold cycle dew forming inside the ties on the metal, let alone rain and tire spray off the road. I'd appreciate the opinions.

Mike