4 speed or torqueflite??

Just did the swap from a 3 speed; auto radiator or cooler, lines, shifter, manual body or kick down cable, flex plate, driveshaft? dunno, as I put a custom Dana in, and needed one anyhow. Same crossmember, speed cable.

I pulled the manual out; a bud came over, and we had the 727 bolted up and on the crossmember in 1.5 hours (on stands.) Don't install the shifter first( I crushed a $50 cable). The metal in the tunnel (lip) needs to be hammered flat. It was easier than we thought it would be.

Now routing the shifter cable away from the headers, grrr. And I rigged the cooler lines in with hi temp hi pressure rubber lines from auto store.

Not hard. Oh, the manual has only backup wires(2). Had to run neutral wire to starter relay.