Super Six Parts check...kickdown part question...
Yes.
Not necessarily. There is no 2bbl vs. 1bbl exhaust manifold; all slant-6 exhaust manifolds from '73 up are identical. The
only relevant difference in slant-6 exhaust manifolds is the choke mount: '60-'65 is slightly different to '66-'69, '70-'72 is way different (open hole covered by stainless cup, instead of cast-in pocket), and '73-up is different again (cast-in pocket with rear wall cut away). If you intend to use the factory choke thermostat and electric control, then use a '73-up exhaust manifold. The better bet is to use an
Electric choke kit number 1232, which will fit any '60-'69 or '73-up exhaust manifold directly and can be installed on a '70-'72 exhaust manifold if the choke cup gasket is in good condition.
- carb
- carb linkages
- throttle cable
The throttle cable may or may not fit your car, depending on the donor car year. See
this post.
See above.
Yes. If your car has A/C, you need the Super Six air cleaner with the flatted front to clear the compressor.
- extra nuts and bolts (manifold stuff)
See
here.
Complete kickdown assembly -- all rods, pivots, brackets, and the lever on the transmission.
Sounds like you have a complete donor car, but if there winds up being a problem with the kickdown, see
this thread for kickdown options.
It is very much worth your while to get the
good gaskets for the manifolds-to-head and intake-to-exhaust junctions.
