abs headliner - newbies like me be careful

I installed my new abs headliner for my '74 Dart Swinger. Purchased from Dante's manufactured by REM.

HEADS UP to newbies like me: Precut holes in the plastic did not line up properly. The seatbelt holes were off by 3 inches and I didn't discover it until I put a bolt slit in the liner at the predrilled location. Don't cut anything until to check it out.

It didn't fit quite right but mostly because it was molded mostly flat and had to be pushed up and in pretty hard. Before you try to put it in, lay it out in the sun and get it nice and warm so it bends easier.

I only swore about 100 times but my wife only called me an idiot twice. Not bad - she usually gets in at least a half dozen on a job like this! The anticipation of doing it was worse than the actual job.