4.0L HO Jeep Engine Build

I should give you all the specs so far:

Crank Bearings: .002"
Rod Bearings: .015"
Crank Axial Play: .004"
Block milled total: .037"
Head Milled Total: .006"
Piston to Head Clearance: .040" (Gasket is .040" compressed)
Head Chamber: 59cc
Piston CC: 15cc
Piston to Wall Clearance: .001"
Piston Pin to Piston: .0008" (3 ten thousandth's over stock spec, my machinist prefers a pin bore a little on the loose side to prevent galling)
Ring End Gap: .015"-.018"

Let me know if I forgot anything.