I need all you nitrous guys...

moper said
Do I read right? It never performed right?

The motor performed very well before the trip was taken to my uncles house where it ran over 240 on a hot day, we figured the heat was what was making the system failed and once it cooled off we tried it and still wouldnt work, so we bought a new solenoid, re assembled and it still doesnt work.. start to pull and falls on its face, just a small burst of power, then it bogs.

moper said
What is you ignition setup?

MSD 6AL, MSD Start retard control, 4 degree chip for timing retard for when the nitrous is activated.

moper said
Did you inspect the plate carefully before you installed it?

I really doubt we took a good look at the plate when we first installed it, maybe later on when we were searching for a problem after the nitrous failed, we will take a good hard look at it and try the brake fluid method you said.

moper said
Are you positive the red side is connected to the fuel solenoid, and the NO2 is connected to the blue?

Couldnt be more positive, one is setup on the back of the motor and one on the front.. so its hard mess em up, Im positive its correct.