Plastic Hood Scoop to Metal Hood?
Well here it is.
As you can tell I am not very good with a cut off, but I can clean it up later.
You can see some bent metal so the scoop would sit right that needs to be cut off, and I need to make more room on the driver's side.
I actually was able to mount it between the hood bracing and the skin- no rivits!
I'd still like to weld a few pieces of metal in where the inserts go.
I bought some square tubing to build a brace underneath and fix the latch area.
It sits lower now, and it is really not too bad driving.
The big question is can I take it to the drive-ins and see the movie?
The air cleaner is not in the center of the scoop, so I had to cut the inner hole on the scoop 'adjusting it' it to the passenger side.
Check out the rear window sticker.