Recent Activity

Activity stream for all registered members at For A Bodies Only Mopar Forum.

  1. toplscuda replied to the thread Eagle hemi carburate?.

    Front cover to run a distributor is just under $1700 by itself HEMI Gen3 Front Distributor Kit

    Dec 13, 2019 at 8:27 AM
  2. Kendog 170 replied to the thread 8 3/4 rear disc swap - ford ranger/explorer.

    This caught my attention. Crown Automotive 476212829K Backing Plate Assembly Kit for 93-98 Jeep Grand Cherokee ZJ with Dana 35 Rear Axle

    Dec 13, 2019 at 8:27 AM
  3. 71GSSDemon replied to the thread Stop on in for a cup of coffee.

    Happy Friday everyone. Day off today, work Christmas lunch today with boss and a couple coworkers. Will try to get some shop stuff...

    Dec 13, 2019 at 8:26 AM
  4. zkx14 replied to the thread Stop on in for a cup of coffee.

    Almost. Little icy outback. But rain next couple days. Good Morning

    Dec 13, 2019 at 8:26 AM
  5. RedFish replied to the thread How to recondition "coated" interior panels?.

    The pre 68 bucket seat backs and skirts were made the same, vinyl attached to steel with contact cement. I've repaired small...

    Dec 13, 2019 at 8:24 AM
  6. Kendog 170 attached a file to the thread 8 3/4 rear disc swap - ford ranger/explorer.

    Look's like you should be grabbing backing plates and e brake set up as well. [ATTACH]

    2009-07-07_160502_1998_jeep_gc_park_brk.gif Dec 13, 2019 at 8:24 AM
  7. DustyDuster replied to the thread Just watched "Dr Strangelove".

    Keep your essence pure!

    Dec 13, 2019 at 8:23 AM
  8. dusted attached a file to the thread Terminator X for the hemi is here!!.

    China LS Tbody to truck manifold using EFi source adapter. Maybe $135 tops.[ATTACH]

    CEA94160-E1D7-4DEE-8DEE-B851DB946C79.jpeg Dec 13, 2019 at 8:20 AM
  9. Kendog 170 attached a file to the thread 8 3/4 rear disc swap - ford ranger/explorer.

    Good Point ! E brake may have drum set up inside the rotor like GM's have. If so, could it be incorporated? [ATTACH]

    rear-disc-2-jpg.jpg Dec 13, 2019 at 8:20 AM
  10. roccodart440 replied to the thread Alloy heads.

    If you are stating that the higher ability of aluminum to dissipate heat from the combustion chamber is nominal. I'd bite on that. But...

    Dec 13, 2019 at 8:14 AM
  11. RedFish replied to the thread 1966 BARRACUDA BUCKET SEAT MEASUREMENTS.

    For a aftermarket vendor to build there products specifically to fit every Chrysler, Ford, Chevy, imports, EVERYTHING,,, that's a sweet...

    Dec 13, 2019 at 8:13 AM
  12. toolmanmike posted a new thread.

    Hot Rod Magazine HP 273 build

    I don't get the magazine but just caught this. Looks like their dyno numbers were damn close to the factory's 235 horse rating. They...

    Forum: Small Block Mopar Engine

    Dec 13, 2019 at 8:08 AM
Loading...
  1. This site uses cookies to help personalize content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.