Separate names with a comma.
I’m almost done replacing the entire floor in my 65 Valiant Vert. It had some Toyota seats in when I got it, which I sold. I have some original...
Got the final piece formed and roughed in. I need to coax the floor up now to match the new panel. But I need to drop the transmission first....
Thanks guys! Appreciate the words! Hoping I can get to the last tunnel piece this week. It’ll be the trickiest one since it has to interface...
Tunnel phase two complete. Still need to clean up the welds a bit.[ATTACH][ATTACH][ATTACH][ATTACH]
Thanks for following! I’ll be welding it in. I’ll be sure to show that when I get to it.
Got the first part of the tunnel done. I’m doing it in three pieces. Next piece will go from end of this one to the hoop. Then from the hoop to...
Finally time to fab the new tunnel.
Got the center section all done. Decided to stitch it all in, instead of just the spot welds. Just need to run the flap disc over it now.[ATTACH]
Finally got the left center piece started. Ran out of wire. Why do welding supplies always run out on the weekend???[ATTACH][ATTACH]
That’s a good idea. I’ll look for that tomorrow.
I think I’d just need the two plates with the reed sandwiches between. I’ll see if I can get this one apart.
I was looking at their bigger one actually. I’d have to modify the tank a bit to bolt if up. Let’s see if I can get these old reeds out first.
Thanks guys! I’ll try to get the valves out. I already rounded out one screw because it was too corroded. I’ll give it another go when I get...
No problem. Looks like 2133 on the base and 1394 on the cylinder head.[ATTACH]
My old compressor was having issues. When it gets to about 80psi, the pump won’t turn over. I figured the reed valves were bad. So I took the...
I like the pin stripe idea. I also like the look of a darker roof panel.
Got all four sections in. Also made the center section on the right side from 18ga. I’ll say it’s not a drop in job but it is damn solid....
I’m jealous of all your nice final paint going on!
Would you be willing to cut out a small area of the firewall? I can get you a picture of what I’m thinking.
Got another section in. These are definitely NOT drop in panels.[ATTACH]
Finally getting some progress again. Lost a few weeks, had to give the house some love. I’ve got one section of the new floor in.[ATTACH]
Got some rust bullet on the inner cowl.[ATTACH]
What color is your motor? I like it.
Are you willing to cut any sheet metal out? I need a few inches around the rear wheel lip.
I’ve got a SBP 7 1/4 you can have for free, if you want to come pick it up. I’m about to scrap it.
I once had someone ask if my 1929 Model A was a sixty-something. Wow.
I can’t wait until I get to that point.
It’s gotta awesome to put finished pieces on for the last time!
I thought I saw someone on here running some hard lines for heater hoses. I recall it looked awesome but can’t find it.
Appreciate the words!
