Separate names with a comma.
I remember last time I bought a set of studs they weren't quite large enough. I'm not near my calipers or an axle to measure but want to order...
Another hiccup I found. The calipers I set back to rebuild were from a 75 Dart. Both calipers had stuck pistons. One was phenolic and the other...
Aspen / Volare spindles will also work. The ones on my 68 Dart are actually from an 85 5th Avenue Chrysler. I had to use 74 Duster big ball joint...
If you require that much volume it would seem the rear brakes are too far off the drum. Disc brakes ride the rotor so that is not where your...
Yes but those calipers are of a different design. That is why I specifically mentioned the A, F and M bodies. They use the same pads which mean...
That is unusual. The factory 10-1571 is a 15/16 bore. My pedal moves a little further down but well off the floor and stops where I want it now.
First off let me give you the link to this super handy PDF master cylinder identification catalog from Cardone that has pictures, bore diameter...
Thanks for all the interest and feedback! This installs in just a few minutes and is plug and play. No wire cutting or splicing on original...
[MEDIA]This is an easy install and a reliable replacement for the fragile and troublesome worm drive motors. Only one 1/4" hole has to be...
Sounds like there was some issue with the ballast start bypass....
I know this is more of a B and C body thing but FABO has the MOST members and viewers...(I did post on the B body site)Tired of replacing gear...
I recently was asked to make a vehicle run properly. It had some carb issues but also a serious ignition problem as well. Check your ROTOR...
I used early upper and intermediate linkages with the adjustable later model lower rod and found it to be a good setup.
The reverse lever is in the case not the cover..... ;)
I am working on a friends 68 Barracuda with a Jegs 408 magum with a 274/474 cam. It sounds pretty salty but is an under performer. It been to a...
Hit it with a hammer several times and work it both directions.
My 71 Demon 440 ran hot with the lower temp thermostats but improved greatly with the 195 degree thermostat. At speed heating can be an...
Welcome!
Does the kick down (throttle pressure) linkage have any spring to it at all when you push back on it? Is it getting any travel from the carb?
[IMG]
Or get the standard one port and use one of these on the other line.....[IMG]
$20 Kinter unit for a motorcycle takes SD or flash drive and has a tuner. I soldered a standard antenna socket into mine and ran an antenna in the...
That is great! What headers do you have?
You say it feels like you are taking of in second... Do you actually feel it shift to all gears?
9/16 deep impact socket usually fits.....
Black Max? I have a friend that uses it to mount sights on high powered rifles and they have yet to come off.....
452 is not a closed chamber head. Any good 750 will feed that engine well. Remember you have a shorter stroke than most brand X small blocks so it...
Torker2 will probably deliver the most in the power band.... right with the Weiand though. Better have some converter though or you'll wish you...
Dog food can lid material under the gasket on the head side and you are good.
A few shots of my cars in these... [MEDIA] [MEDIA] [MEDIA]
