Separate names with a comma.
Looking for a 742 3:73 sure grip unit. Seeing if you know of any?Thanks for your time.
I am on the east side...Chandler
Got another one!
Good to know and thanks for the heads up, I will double check that its not sitting on the pad. I had made it so it JUST slids over, but I'm going...
Here's what I fabricated. bracket slips under back side of dash leaving dash pad untouched. still need to covers wires though.
I have the arm rest plastic bases front and rear.
Sorry distributor is gone
Sorry mine has been sold.
That pic of the snow is great!!! I miss the Chicago winters, and then you guys reminded me of the very reason I moved to AZ. I got sick of the...
8 3/4 Factory pinion snubber $20.00 plus shipping ships from Arizona 85224
Never heard back either!
Top
I did this, basically I swapped out my steering column for a non column shift steering column. I did put a new trans in so the linkage was not...
converter sold
Got these 3.23 gears from a 3rd member out of a 742 case I bought. Don't need them...... Pattern looks good.75.00 plus shippingAZ 85224
Looking for a good used or new 30 spline spool for an 8 3/4.
if you have not done so already measure measure measure...as others have found out, be sure your 36 spline side is 3/4 and not 5/8. just a heads up.
I was not going to post again. But since you took the time you are correct and the response to u-joints and steering shafts of what was mentioned...
Welcome to AZ. If you can make it thru the summers, the winter is worth the wait. I'm done shoveling snow! reside in Chandler.
Stock ignition and harness Worked when pulled out. $25.00+ shippingShips from AZ 85224
I have a torque converter if your still looking.
Do you have any part numbers?Thanks
2 3/4" as measured per your pic. and the outside diameter is 6 7/8".
That looks great.... and expensive! Glad it worked out finally. Enjoy!
Bump
Due to circumstances converter is still available!
My condolences.
Prayers sent to you and your family.
Anyone still looking.. May want to try this...