Separate names with a comma.
No,no,no.just replace the seal.its a lot of work but
i think you are close,pinion should be -1.5 degrees to the ground,cass always told me set pinion opposite of trans and roll it down 2-3 degrees...
or a 3/4" breaker bar and 4 foot piece of pipe
wow i never would have thought
Outdoor wood boiler,with water coil air handler if you don't put the coil in the floor
ive always had good luck with mopar battery.seem to get 8-10 years out of them,but im sure the are all made by the same few companys
i dont know how that happened,i dont know the man to comment on him. my bad.
I don't know what that means?
you wont notice much going from 355 to 373
Sender in question looks just like my original.
its like they have the im to good to help you attitude.and i dont need that.the web is full of great people that take interest and are willing to...
ozzy never wrote a song in his life.geezer did the writing in bs
man thats a bad ass demonic ride.you should be proud
always carry a ballast resistor and ignition mod.in my cars.i take it you dont
nos fuel sender=about impossible to find
489 case , large yoke,391 gears, clutch power lok. Ready to bolt in.$600.00.shipping will be $100.00 as these are heavy.check or m.o.if paypal add...
same here,no complaints or issues.has worked good for me.i would also buy again
I have a Henry Golden boy and absolutely love it best shooting 22 I've ever had I've had it for like 25 years absolutely no issues
my 360 would not real with the black seal,pulled motor back out and installed the orange ish red seal .no a drop since
driveshaft specialists has a conversion shaft
wow that a crazy price.
i got the idea from magnum swaps web page.the only silicone i used was a dab where the rails meet the front
auto parts store just ask for 1995 360 magnum oil pan gasket
i just snugged en up
it was the viton,it was not line honed.i used the magnum 1 piece oil pan gasket,,cut the front off and used the front from a la oil pan with a...