Separate names with a comma.
Maybe one from a A903 3 speed will work.
My youngest brother was there with the 1st Marine division.
318 polly before 62 maybe 8 bolt.
Pink Floyd, Led Zeppelin, Dire Straits, Pete Townshend post Who, ELP, Traveling Wilburys.
About 40 years ago a friend and I went and visited a high school friend of his and this guy was a big mopar guy he had a garage full of stuff....
Was this guy in the Melbourne area ?
Look down the bores with the engine running at idle if you see fuel dripping from the boosters you most likely have a blown power valve.
An older and wiser machinist showed me a trick he used on tear down after removing the spring and retainer put your finger over the top of the...
Tell them all to be there at the same time and let the bidding begin.
Are those part numbers for large or small sector boxes ?
Most likely the replacement brand will be Red Star ( China)
My 63 manual says pack the rear anchor full of multipurpose grease and coat both ends of the bar with grease.
They may have moved the bulkhead connector in 64 to accommodate the cable throttle assy So you may want to look at some photo's of a 63 firewall...
One of the problems is today no one wants paper manuals the old Chilton's and Motors Manuals had a lot of basic diagnostic techniques in them. No...
:lol:What's a snow blower ?
I have one I will measure it for you tomorrow.
Dart would be longer than a valiant 63-66 really only 66 used a slip yoke drive shaft and 67 and later are also different because of wheel base.
Man I feel bad for all you northerners it's suppose to be in the 80s here in Florida on Thursday and Friday.
I believe early torqueflites had the case vent inside the bell housing maybe your overfilling it Check the fluid hot and in neutral idling. And I...
That was the excuse my grandfather used.
That should be the SO or shipping order number not the VIN number
Nope
I don't like them because they charge you multiple shipping charges If you order 3 different items and they come from 3 different locations they...
My 63 service manual say minimum of 125 foot pounds does not differentiate between any Plymouth model but that joint must fully seat.
I would also drop and clean the fuel tank if it's been sitting a long time and replace the filler grommet and fuel hoses.
That's a TRW pumpTry this article a B bodys only need help getting seal or rebuild kit for TRW power steering pump from 1966 satellite | For B...
Tell them to save the ones they have because someday no one will believe all this COVID stuff.
TIG weld them but find someone very familiar with very thin stuff.
Bulkhead Connector From A 65 Abody Not Melted Good Condition With Approximately 2 Inches Of Wire $10 Plus Shipping[ATTACH][ATTACH][ATTACH]...
Come on now we fixed al that 20 years ago we now use paper ballot that are run through an optical scanner and signature verification and voter id....
