Separate names with a comma.
68-72 I meant...sorry
find a set of used 68-70 340 brackets
good deal for someone with a 71 or california emissions 70
I heard there wasnt enough drama for the producers likings so they had to start acting up...
welcome...yes, same trans cross member...
It's a former no prep car of "axeman"
yoke for sure...
sorry just noticed your location...I'll assume us valiant...
Canadian or us 66 valiant? A Canadian 66 valiant is a rebadged dart...
His you tube channel is "TheReal Streetoutlaws"
yep...472...tricia been driving it while heifers down with cracked heads...have you guys seen the hemi nova?
Hope everyone had a good one...God bless all.
I just measured a 69 dart and it was 44" and only about 13" deep
some tubes are mounted from inside, some from out side. If its an inside mount u will need to get the tube in the tank before final placement...
I bought a 69 sport fury no start...ballast resistor later she was a driver :)
Sorry but I like JJ :)
Sorry Roy...that sucks for sure...get well...
The new glass is not as thick...when the guy did my dart he ran a thin strip of butal tape inside the gasket
and reaper the week before
1 and 3 are a body 340 2 is non a body 340 360 driver side and 4 is a Frankenstein lol
by the color I would say milodon
you need a ground from the battery to body
you must remove driveshaft for that type of distance
I think ford uses 3 1/4 tube on their dana's is where the problem comes in. The dodge dana, 8 3/4 and 8.25 have 3" tubes. Some later 8 1/4 use...
I would never use pui on that beautiful car...
If they weren't threaded would they still be nuts?